Instruction, Design, and Technology Certificate

Instruction, Design, and Technology Certificate is a Diploma program taught at Delaware Technical Community College, USA. The program is offered in campus-based modes with full-time options.

The Instruction, Design, and Technology Certificate at Delaware Technical Community College prepares educators to design, develop, deliver, and evaluate educational opportunities. It focuses on using educational technology to support teaching and learning, including helping students comprehend difficult concepts, engage in active learning, access information and resources, and meet individual needs. The program graduate competencies include instructional design, learner-centered teaching strategies, formative and summative assessment, and applying technologies to advance learning.

The certificate follows a course sequence across semesters. Semester 1 includes IDT G10 Foundations of Effective Teaching (3 credits). Semester 2 includes IDT G20 Learning Experience Design (3 credits).

Semester 3 includes elective coursework (9 credits total) selected from approved electives such as IDT G15 Collaborative Teaching Practices, IDT G16 Advanced Assessment, IDT G19 Teaching for Inclusion: Accessible Course Design, IDT G25 Engaging the 21st Century Learner, IDT G32 Implementing Effective Learning Communities, IDT G40 Designing for HyFlex Instruction, IDT G42 Motivational Teaching, and IDT G99 Special Topic in Instruction, Design & Technology.

You must pass the listed courses and earn at least 15 credits to complete program requirements. The program is offered in Dover, Georgetown, Stanton, and Wilmington.

Modules

• IDT G10Foundations of Effective Teaching
• IDT G20Learning Experience Design
• IDT G15Collaborative Teaching Practices
• IDT G16Advanced Assessment
• IDT G19Teaching for Inclusion: Accessible Course Design
• IDT G25Engaging the 21st Century Learner
• IDT G32Implementing Effective Learning Communities
• IDT G40Designing for HyFlex Instruction
• IDT G42Motivational Teaching
• IDT G99Special Topic in Instruction, Design & Technology

The minimum requirements for admission in Instruction, Design, and Technology Certificate at Delaware Technical Community College for all applicants (Domestic or International) are:

• program specific academic requirment set by Delaware Technical Community College.
• English Language OR any other language requirments as set by Delaware Technical Community College as pre-requiste for admission in Instruction, Design, and Technology Certificate.

Note: Please check the university website in the link below.

Please check detail of study units at https://www.dtcc.edu/academics/programs-study/instruction-design-and-technology-certificate/

80 fully funded scholarships are listed for USA. See USA scholarships.